MOTs
Both our Blackburn and Manchester stores are class one and two MOT test
centres. MOT class one covers all motorcycles and scooters with or without a
sidecar fitted up to 200cc.
MOT Class 2 is a motorcycle or scooter over 200cc with or without a
sidecar fitted. The MOT is a basic safety check on a vehicle at the point of
presentation. During the mot we check things like tyres for wear and cuts,
steering head bearings, brakes suspension to name but a few.
Motorcycle MOT Centre Manchester
& Blackburn
The list of what is checked is quite long but what must be understood is
that the standard for a vehicle to pass the MOT is fairly low. Take tread depth
for instance. The minimum depth is 2mm so if the tread depth is 2.5 mm then
that’s a pass. The examiner would be correct to pass and advise. However within
five hundred miles the tyre could easily be below the legal limit.
At point of test we are not looking for a bike to be like new. If brake
discs are warped this would be a reason for failure but only if the fluctuation
can be felt at the lever when the bike is being used. Basically if you can feel
it on the rolling road then you will feel it on the road. But a slight
fluctuation you might not and this would then require a road test to establish
whether the tester is required to fail.
The default position is that we are aiming to pass and only fail when
the item is clearly defined as a fail in the testers manual. A solo presented
for mot should take no longer than half an hour so we always advise you to set
aside an hour for an MOT just taking into account time for taking keys
preparing paperwork etc.
A Motorbike Test Centre & Garage You Can Trust
We are appointment only at both sites for MOT but can usually
accommodate an MOT at fairly short notice as we have a number of qualified testers
at each site.
Book your MOT or make an enquiry using the buttons below or contact us to arrange a visit to our Manchester or Blackburn garages.